Interested to Buy Any Domain ? << Click Here >> for more details...
What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 29925 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / dixit
CT means current x'mer. in actual field high amount of
current in turms of KA so measuring this current is
difficult & also relay current is also less.so, for
reducing current (pri.-high current & sec.-1A OR 5A)CT is
used.
care must be taken that always CT sec. are shorted because,
at sec. less current and high voltage is present. if it is
open than this high voltage affected field operator.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
What are the disadvantages of thermal power plant?
what could be the RMS value and average value of a 4 phase sine wave?
what is the necessity of under ground cables ??
BSNL TTA EXAM QUESTION
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
What are the disadvantages of hydropower?
what is the difference between interconnection and intraconnections in the circuit diagrams
An automatic water heater is an example of which type of control system?
