Answer Posted / syed urfi
Always provide lap in centre half pt of colmn.
| Is This Answer Correct ? | 25 Yes | 4 No |
Post New Answer View All Answers
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?
Moisture content calculation for diff mix ratio's ??
How to plan a project
How many bricks are there in 100cft?
Where can I get a Text Book on Design of Blast Resistant Buildings in PDF form.
Calculation of curtain wall of box culvert
Define mirror?
PLS.......... ANY ONE CAN FORWARD ME PREVIOUS QUESTION PAPER hpcl civil engg
What is the difference between EPC,DBOOT and BOOT.
what radial pressure, the NP2 class rcc pipe can sustain?
Define What happens to Load at yielding ?
Give list of building construction equipment & explain about them in brief. How much is output of JCB, POCLAIN, Steel cutting & bending machine, material hoist, tower crane?
can u plz send me ntpc placement papers(civil engineering) at mohit_verma21@yahoo.com
How to calculate canal slope curvature qty!
