which power plant has high load factor?
Answer Posted / aasha
nuclear power plant
Is This Answer Correct ? | 21 Yes | 1 No |
Post New Answer View All Answers
what is vA rating and class of a ct.
how to control dc motor?
Any one can explaination about calibration with rotating sub standards?
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
What is the difference between vector surge relay (78) and Pole slip relay (98G)
circuit diagram of trip circuit supervision relay
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
what is metering cum synchronizing panel and how it is used?
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
could you measure current in parallel?
what is the purpose that we use PLC system in power system
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?