why free wheeling diode is connected across inductive load
- 16 Answers
- 53850 Views
- NTPC, Omaxe, Wipro, I also Faced
- E-Mail Answers
Answer Posted / venkat parthasarathy
AS the supply cuts off the current will not become
zero,because there will be some energy stored in inductor.It
will create a reverse current.If the contacts seperate the
back emf will damage the cicuit components. Hence the free
wheeling diode is connected to provide a closed path for the
current until it vanishes.....
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
what will happen if i connect 12 volt battery with 24 volt battery charger.
what is resver in electrical enginnering with answer
what is mean by descripiency relay? & wht is its ansi code?
When we connect the large capacitor bank in series ?
what is the purpose of using filters in a protective relaying scheme?
Can a generator runs after getting 1st stator earth fault.
What is the necessary and sufficient condition for stability.
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
what parameters should we check to reduce the power bill
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
Electronic circuit
what is the effect of higher value of GD???
In vapour absorption refrigeration machine fluids used are
