Interested to Buy Any Domain ? << Click Here >> for more details...
Can u start a tube light without a starter?
- 8 Answers
- 34368 Views
- Adani, I also Faced
- E-Mail Answers
Answer Posted / shubham.rakhe
I answered YES!
Tubelight starter is just like a push button. Not of use
once the system is started. When u have switched on the
supply in the TL touch and remove the contacts of the 2
terminals that were to be connected to the starter a several
times so that u generate appropriate di/dt, until the
required voltage is induced in the choke coil that u'll see
as light starting glowing
| Is This Answer Correct ? | 36 Yes | 15 No |
Post New Answer View All Answers
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
Describe the control mechanism of missile launcher???
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
what is cathodic protection and why it use in industries?
How can calculate the rating of a servo stabilizer for given a specific load
which network topology offers the greatest level of tolerance?
where we use the SFU & FSU?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
what does mean of RCT and STR in diffrential CT?
explain the Trip supervision circuit
what is earth pit , how we can measured it, what earth rods reference
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
Why is negative feedback invariably preferred in closed loop system?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
