how to detect the presence of underground cable(while
digging road)etc. -give the name of instrument
Answer Posted / jagannath patel
Mr. Dharma rao can you send details of mfg./supplier.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
thyristor controlled APFC panel design parameter?
how the phase convertor changes the no. of phases
what is ratio of copper wire size and current ?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
what is the safety of voltage power transformer(2250KVA0
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
What is an alternator impedance value?
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
What was your role in the silicon evaluation/product ramp? What tools did you use?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
XYZ