Interested to Buy Any Domain ? << Click Here >> for more details...
how we can differentiate a motor and a generator just by a
glance?
- 5 Answers
- 9693 Views
- I also Faced
- E-Mail Answers
Answer Posted / virendra1981
IN motor Mechanical power is taken out from the Rotor shaft
by applying a power to the Field winding , while in the
Generator by the primover the rotor shaft is driven & power
is taken from the Field winding.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
What will happen if the voltage in my house drops from 220V to any lower voltage?
what is transient stability analysis means?
what is solkor relay and which condition it will act?
Can we put 3 layers of cable tray while installing tray
what is the function of choke in the flourcent tube lights and why the colour is in white mostly in flourcent tube lights
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
How can you sized or estimate the ligthning arrester current rating?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
difference between Ac and Dc mcb ????
what do you mean by class PS CT and what are technical details needed for calculating it?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
