Interested to Buy Any Domain ? << Click Here >> for more details...
why we use 24v dc in instrument rahter than 230vac????
- 4 Answers
- 22408 Views
- I also Faced
- E-Mail Answers
Answer Posted / visakh ctjv
all loop powered transmitters are capable of
withstanding 10 t0 36v dc ...as per the process requirement
it will vary.. insome industries they are using 12v dc
also.. 24 vdc is used because as per ISA there are some
standards wich will match other process reqirement like
24vdc relays for digital control also wecan use 24dc to
energize tis relays
| Is This Answer Correct ? | 22 Yes | 7 No |
Post New Answer View All Answers
what would be the minimum flow rate that we can measure on rotameter..?
how the arrangement of equipments done in control room
Manipulation of dead wt. tester double piston type.
what is IEC code in cables & how to selecting cables?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
what is sil (safety integrity level
Explain Gas Turbine startup and shutdown sequences
What is the basic difference between Modbus and CAN Open Protocols
what is the difference between magnetic flow meter and mass flowmeter
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
What is the GK Value in Flowmeter?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Explain the combusion chamber
selection of the zener barrier for the hazardeous area zone 0
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
