Interested to Buy Any Domain ? << Click Here >> for more details...
how to convert transmitter milliamps output to like
temp,pressure etc.....
- 5 Answers
- 27999 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin patil
i am giving here the formula for the same,
temp/ pressure = (ma - 4)* span / 16
where, ma = what you measured by multimeter
span = max range of the transmitter.
| Is This Answer Correct ? | 51 Yes | 6 No |
Post New Answer View All Answers
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
what is the calibration procedure for transweigh make weigh feeder?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
selection of the zener barrier for the hazardeous area zone 0
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
What are different types of control valves?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
pls give me presant awerness quistion and answer in my emailid.
what is easiest way to read STL language in PLC?
Whatis the reset ofset and control system in instrumentation
What is the purpose of bypass valve across AS valve.
