What is reactance? what is the function in Auto transformer
and why high leakage reactance?
Answer Posted / zan
Reactance is a circuit element's opposition to an
alternating current, caused by the build up of electric or
magnetic fields in the element due to the current. Both
fields act to produce counter EMF that is proportional to
either the rate of change (time derivative), or
accumulation (time integral) of the current. In vector
analysis, reactance is the imaginary part of electrical
impedance, used to compute amplitude and phase changes of
sinusoidal alternating current going through the circuit
element. It is denoted by the symbol . The SI unit of
reactance is the ohm.
in case of auto transformer the windings of transformer
itself makes the reactance.
Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
How to operate a ac chilar plant?
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
What do you mean by dependent and independent voltage sources?
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
Earth bits close or open. Which is correct
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
If you have an earth with pilecap then your resistance is really low. why and how?
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
What is Plank's Law?