Answer Posted / visakh
D ifferential pressure transmitter has two ports,
ie high pressure port and low pressure port , these two
ports connects to the pipeline or tank..etc by a metal
tube.the difference in pressure from the two port strikes
on the diaghpraghm inside the transmitter,then the
dighpragm get a little movement , the transducer in the
transmitter converts the mechanical movemeet to electrical
signal, ie 4-20ma
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How to calibrate an pressure gauge with yantrika test bench?
plz send me general of ongc
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
How many interlocks at turbine? Plz explain briefly
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Gas equation
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
what diffrence b/w plc s7200,300,400
how to check earthing,what is minum ohms for proper earthing
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
How does your previous experience relate to the job you are applying for ?
how can use ram
What is zero elevation and zero suppression?