Interested to Buy Any Domain ? << Click Here >> for more details...
What is an Isolation Xformer? What is the use of it?
- 2 Answers
- 8143 Views
- I also Faced
- E-Mail Answers
Answer Posted / tim lafferty
Isolation transformer means that the device has a galvanic
separation between the primary and secondary. Galvanic
isolation means there is “insulation” that does not allow
current flow or no electrons to transfer between two sides
of the circuit. Isolation transformers can be kV or micro
Volt size. They may be 1:1 or 1000:1 or 1:10,000. The
term isolation transformer does not indicate anything about
the transformer except that the secondary is not electrical
connected to the primary. Meaning the primary and
secondary grounds are completely independent of each
other. The connection between the two sides the magnetic
flux not an electrical connection.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
can any tell me why slope 40% and 80% is calculated in differential protection?
Why is negative feedback invariably preferred in closed loop system?
Difference between ac parallel circuit and ac series circuit?
What is meant by reset level of the relay?
What are the different methodes for calculating the short circuit Current?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what are symmetrical and non symmetrical components in electrical installation.
Bimetal strip used in overload relay what is that,which types of material used for that & percentage.
what is plunger and what's the use of it in motor alignment?
As an electrical engineer what are the responsibilities which i can hold in TCS?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
how to decide no of electrodes for 1600A LT Main incomer panel
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
