Interested to Buy Any Domain ? << Click Here >> for more details...
for a 11kv transmission line what capacity of CTs & PTs are
required?
- 4 Answers
- 11001 Views
- I also Faced
- E-Mail Answers
Answer Posted / alternate_reality
A 100/5 Amp CTPT can be installed for metering purpose in
Indsustries...
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is meant by neutral compensation factor and where it is used
hi frnds...pls send me aptransco previous papers .....pls..pls,,,(madhar.rocking@gmail.com)and suggest me some websites
How phase to phase voltage comes 440V.
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
what is meant by directional earth fault and non directional earth fault? describe both.
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
what is is the potential diffrence between two phase ?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
What is meant by derating factor?
What is electrical diversity factor in electrical installations?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
how to calculate the torque of a motor?
What are the causes for the failures of sandwich type (Al) busducts?
