what is the difference between 3,4 wire RTD sensor?
- 6 Answers
- 14518 Views
- HTA Instrumentation, I also Faced
- E-Mail Answers
Answer Posted / niranjan
RTD is inherently a 2-wire device, A 2-wire RTD can be used with either a 3 or a 4 -wire instrument by jumping the appropriate terminals.3-wire instrument, a 4-wire RTD will not provide any better accuracy. If the fourth wire is not connected, the device is only as good as the 3-wire RTD; if the fourth wire is connected, new errors will be introduced. Connecting a 3-wire RTD to a 4-wire instrument can cause serious errors or simply not work at all, depending on the instrument circuitry.
| Is This Answer Correct ? | 1 Yes | 14 No |
Post New Answer View All Answers
what are the steps I have to deal with?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
what is the input of digital counter during the the calibration time?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
what is a half wave, full wave, and bridge rectifer.
How does your previous experience relate to the job you are applying for ?
What are different types of orifice plates? State their uses.
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
How flow can be measured with dp?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Why not come out analog output in ABB EL3020 when display show correct value
