Interested to Buy Any Domain ? << Click Here >> for more details...
in ac system the current wave form becomes zero for every
half cycle then how can we get continuous supply can any
one answer to this plsss
- 2 Answers
- 5378 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
For a 50 Hz AC system,the voltage or current waveforms
becomes zero after each time intervals of 10 ms(Time period
is 20 ms).
Mathematically, the sinusoidal function is a continuous
function.
Strictly speaking, we do get zero instantaneous values.The
instruments(ammeter,voltmeter),on whose basis the claim of
disconiniuty of supply is argued,measures either average or
rms value which is certainly not zero.
If the CRO is used to see the waveforms it will show
perfactly sinusoidal which has zero as well as other
values.So where is the question of not getting zero values?
If the bulb or lamp is chosen to checking the
continuity,its glow depend upon the rms value,not on the
instantaneous value.So we get continous glow as a
indication of continous supply.But in actual,the waveform
had gone through the zero value also which was not evident
from glow.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what kvrah y we need to take the readind of that
what is the max. acceptable leakage current in 33kv bus bar
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
How to check the LM324 Ic
Define what is power quality meter ?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
what is the effect of power factor of machines in starting current
how to calculate short circuit current for the busbar
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
what do you mean by class PS CT and what are technical details needed for calculating it?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
