what is main reason for grid earthing for any industry
Answer Posted / s m
By making grid of individual pits all the Individual pits
are connected parallel to each other . This reduces the
Equivalent Resistance to less than 1 . Generally in 0.1 ohm
or 0.2 Ohm range only. So this is done to improve the
effectiveness of the Earthing system.
Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
The electromagnetic torque developed is proportional to what in a D.C series motor?
Why can't we parallel Voltage transformer secondary circuits?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
Dear sir, I completed DECE In the year 1995.Now i am working in a private company from last 10 years as an Electrical supervisor.The company having a 1000 KVA transformer.Now i try to apply "C" Licence. I am eligible or not.If not eligible,pls give solution.
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
How line capacitance & line inductance varies with increase in height tower.
Is there any abbrevation for STUB in Stub bus protection
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
why we not used 11kva as a direct our electrnics component.
explain single phase series motor
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???