Interested to Buy Any Domain ? << Click Here >> for more details...
When charging a 20 MVA , 33kV/6.6kV transformer through
regulated (0-6.6 kV or 0-33 kV) source on no load , what
will be the maximum current drawn by transformer from
source and what sould be the source capacity.
- 5 Answers
- 11893 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
for good transformer it should be 0.5%of full load current
for normal it may be upto 1%
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
how to decide no of electrodes for 1600A LT Main incomer panel
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
what are the types of electromagnetic forces developed in practical transformer?
What is stepper motor?
DG cranking voltage?
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
what is per unit calculation?looking for simple and strong explanation thk u
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
how many single tension hardware are required on a double circuit transmission tower?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
