What is the Polarisation index value ? (pi value)and
simple definition of polarisation index ?
Answer Posted / gunasekaran
IR600sec/IR60sec
this value if it is less than 1 that system should be
replace or repaire if it 1.3 ok 1.5 is good 2 and above is
very good
Is This Answer Correct ? | 49 Yes | 11 No |
Post New Answer View All Answers
what is ps impedance test
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
What is the technical difference between On delay timer and a Star delta timer?
How 48-relay (incomplete sequence) functions?
What are the three types of compensators?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
what is the relation between size of the anteena and wavelenghth of radiated wave
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
Can I use star delta connected induction motor for dual supply voltage?
Can RCD's used to protect the VVVF drive if not why.
what are the basic insulation levels & what its Unit
what is the advantages og idmt relay over magnetic relay??
how to calculate slip ring induction motor stator and rotor currents??
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?