Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the motor winding resistance ?
- 21 Answers
- 121157 Views
- Forbis, L&T, OEGI, VTI, I also Faced
- E-Mail Answers
Answer Posted / r.p.samy, national switchgears
Pl check how the winding of motor is connected . Whether it
is Star or delta we have to use 4 probe Ohmmeter ,
preferably injecting a current of 10A . The resistance can
be accurately measured
| Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
what is the working principle of a DG Set, Alternator, & exiter
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
What is the difference between diode and a transistor in terms of the direction of current flow?
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
How much voltage we need to apply in 33kv cable during hipot test of cable
How To increase Knowledge Of boliler regarding To Only Electrical Field..
You are of electrical field and you are going for software? Why
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
after how many spot we must chang secondry cable in portable spot welding gun?
