Interested to Buy Any Domain ? << Click Here >> for more details...
what is combined cycle & where it is used
- 2 Answers
- 10134 Views
- NPTI, Reliance, I also Faced
- E-Mail Answers
Answer Posted / chaitanya pithawa
combine cycle is the combination of gas turbine cycle and
steam turbine cycle.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
How do you control cylinder liner wear?
Explain about front drive mechanism in vehicle
Which reactor uses natural uranium as fuel ?
What are the causes of liner high temperature?
explain the effects of alloying chromium and nickel in stainless steel.
What are the uses of windmill?
What are reasons for poor machinability for IS 2062 steel
How fast is a jet plane?
any one have amw(ASIAN MOTOR WORKS) QUESTION PAPERS OF PREVIOUS PLS SEND ME AT mahendra_yalavarthi@yahoo.com
What is the material used ball screw rod
What is hess law?
What is the difference between Michell type bearing and anti friction bearing and the application.
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What do you understand by timed cylinder lubrication ?
What is the principle of a pump?
