Interested to Buy Any Domain ? << Click Here >> for more details...
IN OLTC we observed "OUT OF STEP" Alarm, we have two
different transformer, when both are in parallel this type
of alarm observed. what's the meaning of this alarm and why
it occurs???
- 3 Answers
- 21748 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthik
For details of the parallel operation of transformer refer
the website:
http://nptel.iitm.ac.in/courses/IIT-MADRAS/Electrical_Machines_I/pdfs/1_14.pdf
According to the literature the cause for the out of step
operation maybe due to
1)Change in voltage ratio
2)Change of polarity
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
A jet of fluid strikes a plate What was the force required to counter it?
Name two low frequency oscillators?
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
WHAT IS DIFFERENCE BETWEEN CAPACITOR AND CAPACITANCE?
define the non synchoronism of synchoronous machine in general g or m??
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
What is the basic principle of operation of alternators/dc generators?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
What do you mean by reach and reach the point of the relay?
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
how can maintaince the acb contactor moveing and fixing kit
