Without seeing the nameplate descriptions of a rotating
machine,Is it possible to say which one is a motor and
which one is a generator?
How would you certain this?
Answer Posted / iamdon
Dear Amit,
Your statement is right except the last line.As long a
machine is in motoring mode it will only take electrical
energy as input not the mechanical enegry.
In the question asked, the intention was to find the
difference on a practical ground.We all are very much aware
of the difference on various techanical grounds but a
laymen would not understand the terms like stator,magnetic
field,armature etc.For them FULLY CLOSED and SEMI CLOSED
are quite easy to interprete.Hope now you agree.
Author:arbelectbit@yahoo.com
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How would you calculate power loss in a resistor?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
Why the arms of delta in a delta-wye power transmission system are kept constant??
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
How to calculate impedance volt in Transformer?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
What is the principal of motor?
List the characteristics of filter?
How many types oil using in transformer ? How many letars using in transformer..?
what is the voltage rating of chiller unit sensors
orifice sizing how done, checking & selection
I Have 3 Phase 10 KW AC Alternator i found one phase weak, so what will be the reason & what action shouls i take to rectify the same.
How to calculate multiplication factor in kva example 500kva ans pls ?