Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / janes
Flange Tapping
Corner Tapping
Radius Tapping = Pipe Taps
Vena Contracta Tapping
D - D/2 Tapping
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What is difference between differential pressure & delta pressure?
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
In turbine what does term CDP, NI, NH, HSSOC means.
What are different types of control valves?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
how to relay switch sense the fault?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
What is the purpose of the analyzer in petrochemical plant?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
What is motion balance principle?
