How to protect the water pump by no load running.
Answer Posted / subrat.das1985
i think we can over come from this problem by using proximity sensor.or by using timer .
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
What is the resistance of the field winding of a d.c. Shunt generator kept low?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
What is slope...? Explain slope 1 and slope 2...?
Can double compression glands be used with regular cables?
what is the responsibility of C license holder in industry?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
what is cascade speed control device?and how this device control the speed of motors?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
How wire size can define in electrical wiring? What is the ratio?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)