Interested to Buy Any Domain ? << Click Here >> for more details...
why microprocessors are named as 8085 ,8086 etc?
what's the reason for this???
- 15 Answers
- 45336 Views
- Bhel, HCL, I also Faced
- E-Mail Answers
Answer Posted / iamdon
The naming of microprocessor indicates historical facts
blended with technology improvements.
1)The microprocessor came in the late 70s(1976).This was close
to 80.so from here 1ST TWO DIGITS were taken.
2)There are 8 bits in microprocessor.Hence the 3RD DIGIT
was tkaen as 8.
3)Before 8085,8086 the CPU of intel corporation was 8080A
which were requiring +5V,-5V and +12V for functioning.
With the advancement in technology, it was possible to run
the microprocessor with single +5V.Hence the LAST DIGIT
were taken as 5.
This was the hidden message behind 8085,
(year)(bits)(supply voltage)
80 8 5
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 103 Yes | 33 No |
Post New Answer View All Answers
why we use copper earthing for neutral while for body GI.
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
briefly explain principle of resistance welding
what is the difference b/w ground & virtual ground?
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
132/66kv sub-station procation ?
As an electrical engineer what are the responsibilities which i can hold in TCS?
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
How 48-relay (incomplete sequence) functions?
How to calculate mf when meter equipment and meter are connected
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
