Answer Posted / iamdon
Very well said by Nithi.
Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
could you measure current in parallel?
help me with the question that might be ask on the interview for technical position
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
STATE USE OF ARC RUNNERS & SPLITTERS ?
What is the working principle of MIG welding? and its out put Voltage?
difference between high and low impedance BUS BAR relay??
What is the difference between Droop vs Isoch Control?
what is diff. between earthing grid,earthing mess, earting grid?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
I want to merge a cable..in between two metering Cubicals which contains CT's and PT's and Energy meter..before taking merger..what are the common things required?
What is making & breaking current ???
what clearance required for 4.5 mva dry type transformer?