Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / iamdon
Incendensent lamp(bulb) works on this simple principle.
When current flow through the filament, it gets heated due
to Cu loss in filament owing to high resistance of filament
(made uo of Tunguston).We know that a heating body emits
radiation. When the temperature of radiating body exceed a
certain value,the radiation comes in visible spectrum of light
and the filament looks glowing.The intensity of glowing depends
upon the temperature of filament which in turn depends upon
the amount of current flowing through the filament which in
turn depends upon the voltage applied across the filament.
For getting full brightness,rated voltage is required
across the filament otherwise bulb will glow less brighter.
(You must have seen the dim light bulb in low voltage.This
is due to above reason).
Since a single battery is not capable of supplying rated
current at 230V.So we need to make series connections of many
batteries for getting required 230V.
Even if we connect a single battery across the bulb.It will
glow megrely since its radiation is not in the visible spectrum
due to less heating. so we cant notice the glow.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
How does a digital electronic meter work??????
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
Please give me a erda placement paper
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
what are the steps involved in generator load test?
What is the earth treantment procedure?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
in non technical way how can u define POWER FACTOR??
Where servomechanism is used?
What is nyquist contour?
why lightning arrestor are made in two stack of insulator but why not cvt
Maintenance of transformer???
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
What is the disadventage of gland earthing(power cable) if any. ?
