Interested to Buy Any Domain ? << Click Here >> for more details...
what is use of substation? Any book on how to instal or
construction of substations?
- 6 Answers
- 13990 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / g venkateshwarlu
The use of a an Electrical substation is either to step
up / stepdown the voltage of the transmission line to suit
the voltage level to be distributed either directly or
indirectly to the consumers. Normally, voltage will be
stepped down for the distribution purpose.
Transmission voltage is 400 KV in India. It will be stepped
down to 400 KV / 220 KV / 132 KV / 33 KV / 11 KV or 415V
level to suit to the requred level.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How good are you in resolving the commercial issues to Employer's advantage?
sugest any typical project ?
sir pls send the je exam - 2008 and other model question papers..
What will be result if we connect LT votage to the terminal of HT motor?
Which power will flow first if we switch on a motor Active or Reactive? How?
state basic meaning of 'INDUSTIAL AUTOMATION'?
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
What is mean by STUB protection?
what is the thumb rule for determination resistance of resistor?
generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for supply.although motors is earthed at two point and having all protection.then why we are using that 1/2 core for earthing the motors.while in HT cable we are using only 3core cable for motor supply.generally lt and mv motors are delta connected and ht motors having star connection.whethere it is having any relation with winding connection( star or delta).all motors i am talking about are dol only.can anybody solve my confusion.thanks...
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
WHAT IS DEAD END IN PROTECTION?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
