Interested to Buy Any Domain ? << Click Here >> for more details...
What is the meaning of coupling and decoupling in the
context of power flow?
- 5 Answers
- 8766 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
There is mainly four quantities in power flow studies viz.
1)Real power(P)
2)Reactive power(Q)
3)Power angle(d)
4)Voltage(V)
Out of these four quantities,
P and d are tightly coupled. This is termed as coupling.It
means for changing P we need to change the d only.Change in
rest parameters(Q,V) will not change P.
Q and V are tightly coupled.It means for changing V we need
to change the Q only.Change in rest parameters(P,d) will
either slightly or not change Q.
P and V are decoupled likewise Q and d.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the function of Governor in Hydro Power Station? What is the Function of Lightning Arrestor Voltage Transformer (LAVT)?
What do you understand by oldham's coupling ?
how to calculate energy of 3-phase motor?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
The Q-facr o of a coil given as wL/R. what will be shape of Q versus frequency graph.
Why air circuit breaker off due to power failure?
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
Efficient electrical earthing in hard rock area
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
what is the cause of voltage dipp or swell in the transmission lines?
What is meant by bus bar protection?
checking procedure of capacitor based motors.used in fans etc?
difference between servo motor and synchronous motor
