what is runout? how it is measure? which is the refrence?
- 14 Answers
- 93095 Views
- Greaves, Magna Infotech, I also Faced
- E-Mail Answers
Answer Posted / rajkumar.r
Runout is a composite control which control form,
orientation and location. Runout is often used to control
coaxiality of diameters.
The conditions for Runout are
-> Datum reference is a must.
-> Geometric tolerance must be specified at RFS.
-> It must be applied to Cylinderical Feature Of Size(FOS).
| Is This Answer Correct ? | 26 Yes | 5 No |
Post New Answer View All Answers
What do you measure in the banana and mountain diagram?
What is the cause of cylindrical liner overheating?
how hydraulic power stearin clutch work plz explain
sir, i need some help by you. sir i want to know there are any industry that give six month training on the basis of entrance examination. sir if there are any .pls send me ans on my email-id sk12005@rediffmail.com pls.
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
Explain how is natural gas better than lpg?
In some engines glycerine is used in place of water for cooling of engine. Why ?
What kind of pipes are used for steam lines?
What is method to calculate the noise level at any point of duct if duct dimensions and air flow is known?
Define thermal conductivity.
Will going from a 3 tap to a 6 tap increase water pressure?
What do you understand by heat treatment?
Hiii...I am from instrumentation dept in last plant and now in new plant management transferrd me to turbine dcs operation...how and which way I can prepare for dcs operation...time is just 1 month...???
What is orthographic drawing?
I am completed diploma in mechanical in 2002, i have 5year experience in materials (purchase) dept,i want to do SAP cource in MM module, i want to know can i complete SAP after diploma cource only, is it usefull to me for further Job opening.
