Interested to Buy Any Domain ? << Click Here >> for more details...
what is the value of current as well as voltage upto which
we will not feel shock and why?
- 3 Answers
- 5923 Views
- I also Faced
- E-Mail Answers
Answer Posted / nithi
shock is mainly depending on the value of current flowing
through our body & also the condition of body(wet(or)dry).
If the current is above 5mA ,we will feel shock .so,shock
doesnot depend on the value of voltage(low voltage doesnot
mean low hazards).As i already said,shock is fully
depending our body condition.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Which material is used for the core of a transformer and why?
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
What is referred to the electron in the outer orbit?
how to select fuse rating for a 3-phase motor ???
How out of step protection relay works?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
What is diversity factor in electric installations?
for opening electrical shop, tips needed.
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
What types of question are done for diploma students in aptitude test
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
write a program that prints prime numbers from 1-20 in digonal form
What is meant by sag?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
