Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mayilsamy ranganathan
we well known that all the generating staions are
interconnected by Transmission line and it is known as
interconnected grid system.The grid system is made to share
the load among all the powerstaion generators.
In a typical grid system the frequency is maintained at
50HZ,it means the generating power and power requirement of
the load is same.Hence in powerstaions the frequency is
monitored continuesly to findout the load requirement,if
the frequency dips below 50HZ,means the generator shaft
power increase and we have to give more input to generator
to meetout the extra load put on the shaft.Hence the
frequency is the measures of load,it is not constant,it is
continueously changing depending on load, we are trying to
bring it constant by maintaining generated power= Load
requirement.
| Is This Answer Correct ? | 29 Yes | 4 No |
Post New Answer View All Answers
describe the fully control circuit diagram of ac drives
how to measure earth resistance of a substation
what do you mean by every IC 74 first digit.why are you using this no.why not using another no.
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
Define transfer function?
what is invertor supply and raw powersupply
derive DC RMS value for half wave rectifier?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What are the different types of controllers?
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
all interview questions with answers of ntpc (2000-2009
What is Servo Ventilated Motor?
Pl. brief about break-down maintenance of machine tool.
