Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if we give a dc supply to a transformer.?
- 10 Answers
- 20203 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish
transformer windings will burn
| Is This Answer Correct ? | 35 Yes | 6 No |
Post New Answer View All Answers
What is the end effect of linear induction motor ??
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
Please give me a erda placement paper
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
State norton’s theorem?
how did the testing of protection relays done through current injection
Define transfer function?
What is miller crystal oscillator? Explain its operation?
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
why single CT used in DOL starter power circuit?
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
