Interested to Buy Any Domain ? << Click Here >> for more details...
Determine the minimum cable size for a 28A single phase
final sub circuit originating from the distribution board
supplied by three phase submain. The route length of the
final sub circuit is 54 m. Assume 1% voltage drop in the
consumer's mains. Submain specification: Cable: 50mm2 4
core V75 copper; Route length 42m; Maximum demand 135A per
phase
- 1 Answers
- 5400 Views
- I also Faced
- E-Mail Answers
Answer Posted / james santhosh lenin
3x4sqmm(phase,neutral,earth
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
What the main causes of transient interruptions on Over-Head Distribution Lines?
why -48 volts dc used in telecommucation
why dc is used in control circuit for mv & hv switchgear instead of ac
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
State the factors, for the choice of electrical system for an aero turbine.
Difference between megger test equipment and contact resistance meter test instruments?
What is a copper loss or i2r loss pc?
can u give me a brief idea about power line carrier communication ??
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what do u understand from filter factor of reactor?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
