Interested to Buy Any Domain ? << Click Here >> for more details...
Why Parallel operation of two Transformer are Required?
- 6 Answers
- 14401 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahendra
Becoze when connecting Xmer in parallel frequency ,Voltage
and phase Sequence should be same.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
how to calculate the fault in substation
what are the main applications of transistor in non-linear region?
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
operation of protection relay watchdog contact?
what is meant by LCR meter? where its useful ?
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
How much weight an electrical engine can pull??
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
what are the protecyion of transformer & generators
what is d check in dg 1500kva
