Interested to Buy Any Domain ? << Click Here >> for more details...
What are causes of cracks in outside plaster of a building
and how we prevent it during constructions?
- 6 Answers
- 12681 Views
- I also Faced
- E-Mail Answers
Answer Posted / aung
crack can repair
to avoid causing these make sure curing,
wet the bricks before placing ,
bricks absorb water form plaster motor cause these crack also
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
How many % we consider for lap for reinforcement for estimates
How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 600 microns?
I want to join bhel because
how many tonnes equals to one cubic feet?
how much cement and sand consuptin in 4 inch siporex walls 100 sq ft
Can we apply curing compound on ceiling (slab Bottom)
If a slab concrete is placed with M-20 grade concrete, actually it has to be placed with M-30. what are the rectifications / measures to be taken after concreting is done.
What happens when water mixed with cowdung is used for priming instead of water for lifting water in pumps?
how to calclate the SHUTTERING TAKEN CONCRETE LOAD? WHAT IS THE LOAD BEARING CAPACITY IN STEEL SHUTTERING PLATE? WHAT IS THE CONCRETE LOAD IN (MASS) IN THE SHUTTERING PLATE. PLATE SIZE IS 120CM* 90CM CONCRETE WALL LENGTH IS 10M ,WIDE IS 60CM, HEIGHT IS 1.2M PLS TO SENT THE CALCULATION.
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
A rock anchor 3 1/2” in diameter is placed in rock. The which has an allowable shear strength of 1200 psi. Determine the required anchorage length to safely carry a 80 ton load using a 2.0:1 F.S
how much used soil in 1 brick of standard size?
what is hydrostatic paradox?
What is meaning of Canceled/Flat Beam. What is difference between them? Both type of beam can bear same load if size (width)of the flat beam is increases and depth is same as slab thickness? Kindly suggest to me.
What are the advantages of cad software’s?
