Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the earthing resistance of an industrial
substation and also What should be the house hold earthing
resistance?
- 20 Answers
- 113566 Views
- Jindal, Pharma, TAAT, TATA, I also Faced
- E-Mail Answers
Answer Posted / mitesh v dixit
industrial earthing resistence should be very betwwen .5
ohms to 5 ohms.
0.5 ohms-excelent
0.5 to 1 ohms- very good
1 ohms to 1.5 ohms- good
1.5 to 2.0 ohms-satishfactory
2.0 ohms to 5 ohms- not satisfactory.
note imp- This resistence consider of near induviusal
earth pit only.equipement earthing value should be very
betwwen 0.5 ohms to 12 ohms depending on size & distence of
earthing netwerk(GI PATTI OR COPPER PATTI OR WIRE)utilise.
| Is This Answer Correct ? | 43 Yes | 7 No |
Post New Answer View All Answers
what is submersible pump?what is different between motor and sub motor?
Iwould like to know barc interview questions
Why AC current leads voltage in capacitor and how?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
Why the cores of large transformers build up of circular cross section?
when elecromagnatic waves are propogated in a wave guide?
what r the checklist while installing 500 kva transformer
What are approaches to tackle sedimentation problem of reservoir?
how was your last weekend.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
why impudance relay used for medium transmission power system? why not others?
What the main causes of transient interruptions on Over-Head Distribution Lines?
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
