Interested to Buy Any Domain ? << Click Here >> for more details...
What are the typical values of characteristic impedences of
overhead line and underground cabel?
Why there is so much variation?
- 1 Answers
- 4293 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
Characteristic impedence of overhead line=400 ohm
Characteristic impedence of underground cable=40 ohm
Characteristic impedence= Square root of (L/C).
In case of overhead lines L dominates so higher
Characteristic impedence.
In case of underground cables C dominates(conductors are
very close to each other) so lower Characteristic impedence.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the purpose of shading ring or shading coil in electrical equipments.
Efficient electrical earthing in hard rock area
kindly send me 11KV MV motor differential protection procedure by primary injection method.
Why is the air gap between the pole pieces and the armature kept very small?
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
what is the use of permanent magnet generator in exciter
Define super node?
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
How DC earth leakage currents can be reduced ?
what is the difference between general inverter and solor inverter clerly explain plz
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
Batteries. What is the difference between Lead and Nickel batteries ?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
