Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / iamdon
The generating voltage is limited up to 22kV due to
following reasons.
1)At voltage greater than 22kV, it is not ecomomical to
design the insulation for generator.
2)With the increase in voltage,armature current increases
which causes more loss in winding.So temperature of winding
increases which in turn rise the temperature of machine.So
we need more efficient cooling technique which is again
uneconomical.
Techinacal data:
1)5 degree increase in temperature reduces the life of
insulation by a factor of half.
2)20 degree increase in temperature reduces the insulation
resistance by a factor of half.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
why 1.7Uo for HV cable Hi pot test?IE standard why?
What is current divider rule (cdr)?
what is fault level of power system ?
how to calculate transformer turn primary & secondary side 11kv to 420v
how invertor convert the dc into ac give brif detail
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
what will happen if frequency is below 50 hz?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
bus bar design conditions and sizing pls tell me quickly
What will be result if we connect LT votage to the terminal of HT motor?
