Interested to Buy Any Domain ? << Click Here >> for more details...
How to decide the input and output circuit breaker for a
1600kva transformer.Is there any calculation is involved.
- 5 Answers
- 11455 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajeshsan
The circuit breaker is selected based on following factors.
1. Voltage level
2. Fault current.
3. Type of Breaker.
4. Operating Time.
5. Number of operations.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How can we checked Killo Watts of Motor & Alternator?
What is step signal?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
block diagram of 2 ups system connected in parallel mode?
Please explain, how to test vector group of tranformer(Delta y1) . Thank
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
what is the difference between c power and U power acb breaker
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
Load transfer in 11kv double busbar switchgear - operation.
could you measure current in parallel?
What is mean 2XWY
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
