what is slip rings in an induction motor&what is it's work.
- 4 Answers
- 6295 Views
- I also Faced
- E-Mail Answers
Answer Posted / sree kumar
it is an electromechanical device which transfers power and
electrical signals from stationary to the rotating
structure.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
what exactly commisioning work does in electrical site work... LT side?..
What are the basic & Majour problems in UPS ?
How to check the cable fault / hv test of transformer cable.
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .
what is the reqirred voltage in HT motor to get full RPM on no load test?
What is systematic error?
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
Explain how to determine capacitor tolerance codes?
How harmonic block test are conducted on relays ( Siemens,Areva ect )power transformer using omicron kit?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
what are the possible reaons & remedies if resistance of NGR getting heat up
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
What do you mean by ratio correction factor of instrument transformer?
