Why the brushes used in dc machines are made of carbon not
from other metal?
Answer Posted / rajeshsan
Brushes with metal will lead arc and more wear & tear, Hence for large rating we will use carbon brushes. And for toy motor and very small motor use metal brushes.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
what is cascade speed control device?and how this device control the speed of motors?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
wish of these transformer uses oil?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
difine electrical ballast in HPSVL
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
What are the advantages of hydropower?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
what is difference between 5A and 100A CT constructional wise and operation?
What is nyquist contour?
why to use freewheeling diode ( diode in revers bias mode) across dc coil