how rating of transformer is selected for any new
plant/what kind of load is cosidered/what kind of fadtors
are considered/ pz give standard procedure
Answer Posted / rajeshsan
The rating of Transformer is sized based on many factors:-
1. Total load demand
2. Design margin
3. Continuous load with certain margin with intermediate load
4. In case of Thermal Power plant, Factors like Worst coal, Test block condition for Worst coal..
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
Starting current of a 10 HP induction Motor is ______ time’s full load current.
Is the theorem applicable to ac sources?
how to calculate transformer turn primary & secondary side 11kv to 420v
l&t switch FN 63 handle position can we change
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
grr resistance & contrator malt continuous
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
why occ characteristics of generator is also called as magnatization characteristics ?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
what are the principles of a booster converter?