Interested to Buy Any Domain ? << Click Here >> for more details...
1) what is the use of pin and plate vibrators during slab
casting? 2) how much cement bags are required for 1sqm
4inch brick wall? 3) Is it viable to provide overlap at
column , beam & slab junction. if no why? 4) if bar dia is
changing in column reinforcement , which dia bars overlap
is considered? 5) what is isolated and ecentric footing?
- 4 Answers
- 19051 Views
- I also Faced
- E-Mail Answers
Answer Posted / sk
1.vibrators are used to compact the concrete placed to make
it homogenous mass removing air voids present in it.2.0.2
bags per sq.m 3.no.because it falls in critical zone
4.higher dia bar dia considered 5.isolated footing is a
footing having single column and cg of column and footing
pass from same point.
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
What is the difference between EPC,DBOOT and BOOT.
Use of coping on terrace wall and in 4" wall is compulsory or not ?
What is the distance between railway tracks?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
pls mail some more tecnical qustions at msaranya2610@gmail.com
how can calculate cutting length of diamond ring
how many kg cement & fine sand reqird in one sq meter 1:6 mortar ratio?
Define What are the reasons for geotechnical site investigations in Uganda?
How to make a c++ program that converts any base to base 10?
A sieve analysis results in 100% retained in no. 50 Sieve, the fm is?
What is the average density of soil?
What is the cost of formwork for columns/beams/rcc walls also what is the cost of shuttering for roof slab at height of 25 feet
length where bent up is made in slab of bridge from one end
Define What does civil status mean?
Explain how you can use different dimension tools in CAD? What are the different dimensions available?
