What will happen if we give transformer a dc not ac
Answer Posted / jyoti
NO FLUX WILL TRANSFER FROM PRIMARY SIDE TO THE SECONDARY
SIDE.HENCE THE TRANSFORMER DOESN'T PERFORM.
Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What is the formuala to calculate the rating of motor protection circuit breaker
What is the effect of positive feedback on stability of the system?
What is an 86-P or an 86-A trip
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
Define branch?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
What do you understand by avr?
can we install HT panel & LT panel side by side or how much clearance is required ?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?