Interested to Buy Any Domain ? << Click Here >> for more details...
what happens when ac supply is given to D.C motor.
- 17 Answers
- 32142 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish
dc motor does no work on ac.it will not rotate because in
india ac frequency is 50 hz so the time of half cycle is
only 10 ms.this time is too short to move because of its
inertia.
but expeptionaly dc series motor will rotate when it is
given to ac supply.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what is the acceptable limit value for Desolve Gas Analysis/
What is the practical way to calculate the cable size for known ampere load?
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
IN 1000kva transformer where the oil and winding temperature sensors is connected
What is the basic principle of operation of alternators/dc generators?
What is star-delta transformer?
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
what are the disadvantages in GIS over AIS
I WANT TO INSTALL LIGHTING ARRESTOR ABOVE 20 FEET HEIGHT INDUSTRIAL BUILDING. NOW IT WAS 15 FEET HEIGHT HOW MUCH DISTANCE IT WILL COVER & HOW TO CALCULAT THE DISTANCE COVER BY THE ARRESTOR
What is the distance between each insulator in 33kv transformer and how can it calculate
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
how to calculate the conductor size for certain KV transmission line and distribution line?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
