Interested to Buy Any Domain ? << Click Here >> for more details...
Waht will happened if reactive power increase in the line?
waht about active power increase too?
- 3 Answers
- 10378 Views
- I also Faced
- E-Mail Answers
Answer Posted / nishad
Above answer almost correct. Eventhough I would like to add
something.
In Load current there are two components 1> active
components which is the current consuming by the custmer.
2> Recative components which is the current responsible for
the system, lead to lag / lead.
well, If reactive power is increased, PF will be lag. means
the system will carry more current for the disered out put
the same of unity PF. So our losses will increases like
more bigger size cable, breaker we need.as well as our
power system will over loaded. as reasult CU loss & Iron
loss will increase. so try to avoid that stage.
If active powre increase, then also system will over
loaded. to avoid that, share the load of particular system
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
THERMAL CAPACITANCE IS MEASURED IN..................................................
What is the difference between PLC and Embeded system
How i can decide that HVDC line is best for transmission.
What are the two basic types of transformers?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
what is dry and wet frequency withstand voltage? why & where it is used??
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
how to determine Sq.mm size of finolex power cables.
Transmission through a short line depends on
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
State the methods of improving power factor?
