Interested to Buy Any Domain ? << Click Here >> for more details...
What are the differents between Breaker & Contactor?
- 8 Answers
- 63071 Views
- I also Faced
- E-Mail Answers
Answer Posted / nishad
Above answer is almost ok. How ever I just add a little
with that.
Basic difference between circuit breaker and contractor is
That, A circuit breaker can make, break and carry current
in all conditions i.e normal, overload and short circuit.
It will protect the system from over load, Earth fault &
unbalance as well as it has different load & trip setting
and it don’t want any fuse back up. That was not inbuilt in
contactor. A contractor can make, break and carry only in
normal and overloaded condition not in short circuit
condition. Also, Contractor are always backup by HRC fuse
where as there is no need of any backup in circuit breaker.
For frequent operation, contractor is more efficient than
the Circuit breaker.
| Is This Answer Correct ? | 24 Yes | 4 No |
Post New Answer View All Answers
Explain Even and Odd signals?
is it possible to test of bus bar in high rise building without completed full floor ?
How earthing/grounding done in aeroplanes and ships.
What does Bode plot tell you?
Why can't we parallel Voltage transformer secondary circuits?
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
what are the assumptions made in swineburne's test?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What is the importance of counter based plan & how is it scheduled?
What is effect of over voltage and under voltage on ACB
why don't we use the generator as a motor? and what will happen?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
