Interested to Buy Any Domain ? << Click Here >> for more details...
how to calibrate a control valve?
- 7 Answers
- 63826 Views
- Reliance, Telecon Systems, I also Faced
- E-Mail Answers
Answer Posted / azmat
To calibrate a valve first check the input signal range if
it is 0.2 to 1.0 Kg/cm2 or different.
Calculate the span ( Difference between higher limit to
lower limit=1.0-0.2=.8 ) Now divide it in four equal parts
that is 0.2 Kg/cm2 this is 25% of the span.
Now check the valve travel like 2 inches, 3 inches or any
other value Divide it in four equal parts 25% of the travel.
Apply 25% of the span value+ 0.2= 0.4 Kg/cm2 it is 25% of
travel and apply full span value and see you get the
complete travel if you find difference adjust the spring
accordingly.
| Is This Answer Correct ? | 82 Yes | 10 No |
Post New Answer View All Answers
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
which type of signal used in instrument?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
How the sizing of the analog signal cable is calculate?
Why not come out analog output in ABB EL3020 when display show correct value
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
how to calibrate load cell
Please can anybody help for control valve sizing step by step procedure?
What is the diffrence between ff tx and non ff tx
where proximity sensor installed on tank in loading arm application
why we are using digital signals for I/O & how to measure this signals is getting or not ?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Isometric drawings are generated during _________________ phase of a project
What is frequency factor in massflow meter? When using frequency output?
