Interested to Buy Any Domain ? << Click Here >> for more details...
i am working in thermal power plant .
if temperature transmitter is not showing reading in dcs
then how can we rectify the problem?
- 8 Answers
- 16043 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / satish
SEE THE FIRST ALRM CONDITION ON TRANSMITTER BECAUSE MOST
PROBABILITY IN PRIMERY ELEMENT PROBLE.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
How to erection of DCS Panel at site step by step
Whatis the reset ofset and control system in instrumentation
What is intrinsically safe system?
principle of automatic votage regulator
What are the type of bonnets in the control valves?
How to decrease opening & closing time of on/off valve?
how do calibrate the valves.. with clear manual
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
can we create an interrupt in plc through scada?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
key exchanges in wpa,wpa2,tls
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
What is instrumentation instrumentation engineering?
